From 6c57553e88011a3eb5400a92b57ddbfaed47d654 Mon Sep 17 00:00:00 2001 From: Mikayla Date: Wed, 1 Mar 2023 13:06:14 -0500 Subject: [PATCH] Updated Operating Procedure (markdown) --- Operating-Procedure.md | 16 ++++++++++++++++ 1 file changed, 16 insertions(+) diff --git a/Operating-Procedure.md b/Operating-Procedure.md index 086a7c3..37f5f6c 100644 --- a/Operating-Procedure.md +++ b/Operating-Procedure.md @@ -14,14 +14,30 @@ There are 4 main button controls in addition to the burn rate spinbox control. T ### Setting the Burn Rate +image + While the reactor auto control mode is set to "Manual", the burn rate can be changed via the up/down arrows. The rate is not set until the SET button is pressed. If this succeeds, you will see the "Commanded Burn Rate" show the new rate. If the reactor is active, the "Burn Rate" should also show this rate. ### Starting and Stopping the Reactor +image + +> Reactor is ready to start + The RPS is tripped via either manual SCRAM with the SCRAM button or a detected safety issue. Before starting, the RPS needs to be reset using the red RESET button. If the hazard condition is still present, it will trip again. While it is tripped, the START button will be disabled. Once everything is all set and the reactor auto control mode is set to "Manual", then the START button will be enabled, turning blue. Once started, that button will again be disabled. +image + +> Reactor has been started + +**NOTE THAT THIS IMAGE IS FOR AUTO MODE, GET A NEW IMAGE** + To stop the reactor manually, press the SCRAM button. This will trip the RPS, stopping reactor operation. The "Manual Reactor SCRAM" indicator will light up on the [reactor annunciator panel](https://github.com/MikaylaFischler/cc-mek-scada/wiki/Annunciator-Panels#main-panel). +image + +> Reactor has been SCRAM'd + ## Alarm Panel image